[SCAD] Shoelace Eyelet (customizeable) 3D Printer Model Free Download

3D Printer Models

[SCAD] Shoelace Eyelet (customizeable) 3D Printer Model

Author: @jhnphn431

License: CC BY-SA

File formats: scad,stl

Download type: zip

Size:161.5KB

The file '[SCAD] Shoelace Eyelet (customizeable) 3D Printer Model' is (scad,stl) file type, size is 161.5KB.

Description Files (6)

Summary

Plastic eyelet reinforcement for shoes with laces.

v3 comes in 3 pieces. The eyelet shaft and TWO washers.

The eyelet shaft slips thru the eyelet hold. Slide the bigger washer from the inside of the shoe. Slide the smaller washer onto the shaft from the outside of the shoe.

v3:

Modified to take in two washers to afford some customization.
If the washers break, you just need to reprint washers.

v2:

The v2.stl file should fit most shoes running standard 7mm width flat shoelaces.
Instead of crimping the washer into the eyelet host, slide in from the side instead. It was too difficult to print a crimp that is large enough for retention but also easy to press the washer through.
Washer has a gap for bending and slipping into the eyelet shaft.
The eyelet shaft is now a solid shaft instead of flanges.

v1:

Minor tweaks to original Customizable Eyelet.
4mm diameter for shoelace eyelets.

Recommended: Print at 0.07mm ULTRADETAIL. Go as fine as necessary until overhang warning (without support) on the hook goes away.

v1.scad	3.1KB
v1.stl	175.2KB
v2.scad	4.1KB
v2.stl	184.4KB
v3.scad	4.9KB
v3.stl	277.6KB

[SCAD] Shoelace Eyelet (customizeable) 3D Printer Model

Summary

You might also like