I purchased the board only from HFSignals, so it turned into a 3D printing challenge.
I was inspired by the remixed listed of mark which I found on GroupIO:
https://groups.io/g/BITX20/topic/v1_sbitx_3d_printable_case/103872075?dir=desc
The next challenge was printing it on my new Banbulabs X1C which the bed is shorted by 8mm :-(
So I started to split the models, and as such made some changes to host my different display, add some push buttons and the ATU-100 antenna tuner.
For the antenna tuner, I got the concept from the extremely detailed design of Derk Kenig:
The support legs taken from this great design of Bob:
https://www.printables.com/model/734871-sbitx-tilt-legs-for-portable-operations
Note that the design is for this 7 inch display I purchased on Ali:
7 Inch DSI Touch Screen for Raspberry Pi 5 4B 3B+ 3B IPS Display 800*480 LCD MIPI CSI Cable With Standard Monitor for RPI 5 Pi5
https://a.aliexpress.com/_ooiZkXh
Everything is printed with PETG. Did some experiments with ABS but model was lifted from hot bed so I gave up.
My mistake was not waiting to get SOLID PETG, so the text could have been with much better contract.
Nobody is perfect...
| 4SW_Holder.stl | 87.0KB | |
| Big_Knob.stl | 8.2MB | |
| Bottom_case_Main_Split.stl | 1.4MB | |
| Bottom_Case_Side.stl | 775.7KB | |
| Display_frame-Knobs.stl | 225.4KB | |
| Display_frame-Main.stl | 541.8KB | |
| Display_Frame_No_Call_Sign.stl | 530.5KB | |
| Feet.stl | 640.1KB | |
| PI_COVER.stl | 199.9KB | |
| Small_Knob.stl | 8.7MB | |
| Speaker_Adapter1.stl | 104.4KB |
