A TPU handle for a glass saucepan cover that I had.
Designed to use a M4 screw (The metal washer on the picture is probably overkill, I dont think it's really needed but I had it)
I would not try to print this handle in PLA or PETG... I dont think it's heat-resistant enough. Sooner or later, a saucepan will reach at least 100C when cooking and a PLA or PETG part will likely deform before that. I havent tried though... might be wrong about that.
Print Settings :
Wall line count : 4
Wall line width : 0.8mm
Layer Height : 0.2mm
Infill : Triangle 30%
No Support
| Poignée_Chaudron_TPU.skp | 88.0KB | |
| Poignée_Chaudron_TPU.stl | 29.6KB |
