I used my Saturn2 once, then had a headache. The next time I went into my office, the smell was terrible. Not a good thing.
I designed this venting system that connects to a bathroom extractor fan fitted to the wall, vented outside.
I am lucky that I have an FDM printer and the Saturn2, so this was printed on my FDM printer. I cannot see a reason why it will not print on the Saturn 2.
I have given full instructions in a PDF so will not duplicate everything here.
Let me know if you make it and what you think.
| 01_Vent_5_inside_washer.stl | 67.8KB | |
| 02_Vent_5_Mag_Plate.stl | 219.0KB | |
| 03_Vent5_Vert_Top_Cap.stl | 309.7KB | |
| 04_Vent_5_Vert_top.stl | 200.0KB | |
| 05_Vent_5_Vert_bottom.stl | 417.1KB | |
| 06_Vent5_Outlet_Back.stl | 166.4KB | |
| 07_Vent5_Outlet_Front.stl | 484.8KB | |
| 08_Vent_5_Horn_and_Connector_Ring.stl | 191.4KB | |
| 09_Vent_5_Hose_Connector.stl | 187.1KB | |
| 10_Vent_5_wall_mount.stl | 214.2KB | |
| 11_Vent_5_wall_mount_Ring.stl | 100.1KB | |
| 12_Vent_5_magnet_cover.stl | 12.4KB | |
| 13_Vent_5_flat_cover.stl | 174.6KB | |
| Vent5_Instructions.docx | 7.6MB | |
| Vent_5_90_bend.stl | 275.6KB |
