Decided to resurrect my Sapphire Plus from the garage and attempt to build a new klipper based machine on the back of the amazing Bigtreetech Manta M8P, seems a fair bunch of Sapphires are going that route, Couldn't find a mount in thingiverse so made one here. The screws on the case are not a perfect fit, I decided to add a couple of 10mm magnets in the frame, but to be honest it probably doesn't need them, if you do decide to use this and want to add the magnets use the 'change filament' post processing feature in Cura to stop at the right layer to insert them, from memory my layer was 17, but yours may be different. I also made a frame mount for a 4010 fan to cool the board, again if you use this don't fit it before you have wired up your board (use temporary screws for that) then once you have it all working you can remove the temp screws and use longer screws to hold the fan mount and the board in place. PLA is just fine for this.
| Fan_Frame.stl | 122.8KB | |
| Manta_M8P_Sapphire_Plus_Mount.stl | 96.2KB |
