You are very welcome to experiment with the first layer pattern. ‘Octagram spiral’ and ‘Hilbert curve’ are my favourites for this purpose.
Printer settings: - Filament: I recommend using PETG, ABS, PLA. Avoid Flexes as they will be very loose.
- Layer: 0.2mm - this is crucial.
- Infill: no
- Walls: 3 walls, 3 bottom
- Supports/rafts: not required.
Following changes are done:- Back wall was increased from 0.92mm to 1mm in order to match camera modules ‘hill’ and adopt model to 0.2mm layer print.
- Added a cutout for magnet phone holder plate.
- Buttons cutout was completely changed.
- Top and bottom cutouts were increased as the origin model had been cracking and didn't fit (PETG).
- Display border edge was quite sharp and too high that had been making side swipes almost unusable. Now it is less high (-0.2mm) and more blunt.
Tips for creators are always welcome. Just hit "Tip designer" above :)
