Samsung Galaxy S21 Plus Case with open back, PLA based design
THIS WILL NOT FIT S21 Ultra or S21 FE
FITS PHONE WITH DIMENSIONS OF 161.5 x 75.6 x 7.8mm
the back was made to be printed on an any cubic photon in a clear resin and be joined on later but should work with any printer. CAD files are included allowing you to make changes if you desire :D
NOTE:
This case was good enough for me but can be improved with more clearance on the buttons for your fingers and a slightly tighter width (like .5mm) for a better fit. In addition, the bumpers on the front could stick out further for added safety. This case will probably not work in tpu and slip off too much.
I was annoyed there were no free options for phone cases so I spent a few hours making this for everyone, I hope you enjoy!
Case.stp | 319.2KB | |
caseback.stp | 48.6KB | |
S21_caseback.stl | 40.9KB | |
S21_Case_v3.stl | 542.0KB |