I made this in two separate pieces on tinkercad and initially the stick was too thick, so I had to shave it down a bit! There's a small hole in the lollipop's mouth, but it'll be covered when you put the stick inside. Please let me know if the stick is too wide or too narrow (though you can shave it down or use hot glue to make it fit if that's the case.) I printed the face with normal speed and the stick on fast, so they are separate prints. Make sure to put glue down before printing the stick. No supports or brims necessary and I printed this at 15% infill.
There are 3 sizes: Huge, medium, and small
I would print the medium and small ones at fine speed.
This is one of my very first designs and prints so I would love feedback!
Happy early Halloween!
| Sam_Lollipop_face.stl |
| sam_lollipop_medium.stl |
| Sam_Lollipop_small.stl |
| Sam_lollipop_Stick.stl |
