This little project is very worth it if you can pull it off before your next costume-related event. I used a 1/2" PVC dowel for the body, the rest is 3D printed. You don't have to install the LED, resistor and AA batteries, but they certainly enhance the effect.
If you choose the non-lighted route, you can just substitute the PVC pipe with a 15.5mm diameter wooden dowel (and not have to print the two connecting dowels). Just insert the wooden dowel directly into the two crescent moon halves and end tip. This option takes far less time than the other. In either case, just print everything out and glue it all together.
This Healing Wand compliments this Neo Queen Serenity costume:
http://www.thingiverse.com/thing:1096688
You may still have time before Halloween to pull this off... Get started NOW!
Here it is in action:
We expect to see pictures if you decide to carry this out. :)
Oct 30th, 2015 update: here's the locket from Season 1:
http://www.thingiverse.com/thing:1101606
Dec. 3rd, 2016 update: Here's an awesome remix that you have to check out!
http://www.thingiverse.com/make:272678
June 14th, 2017 update: Mirrored the front side to make a single piece so you can print in one go. Hope you don't mind both sides looking the same.
| CrescentMoonBack.stl | 1.8MB | |
| CrescentMoonFront.stl | 4.7MB | |
| CrescentMoonWandEnd.stl | 204.0KB | |
| CrystalPrismBall.stl | 1.2MB | |
| HealingWandFull.stl | 1.7MB | |
| WandDowel.stl | 966.4KB |
