Sagrotan® / Dettol No-Touch Soap Dispenser Refill Lid – V2.0 3D Printer Model
The file 'Sagrotan® / Dettol No-Touch Soap Dispenser Refill Lid – V2.0 3D Printer Model' is (STL) file type, size is 1.5MB.
The file 'Sagrotan® / Dettol No-Touch Soap Dispenser Refill Lid – V2.0 3D Printer Model' is (STL) file type, size is 1.5MB.
This makes the "Refills" of the No-Touch Soap Dispenser really refillable
The lid needs to be printed with TPU. With inflexible filament it will be very difficult to remove the lid again.
A 15 mm hole must be drilled in the centre of the refill container. I used a Forstner Bit on a drill press with a vise to drill the hole into the empty Refill Container.
The lid is not watertight, it just seals the soap against dust and makes the container look neater.
To also reduce the wastage of soap I used this adapter:
https://www.thingiverse.com/thing:3240308
Works perfectly!
Edit 25.6.2023:
At the suggestion of "Panik28" I added two jigs to make it easier to drill the 15 mm hole right in the center of the refill container.
With the 3 mm jig you can use the tip of a 3 mm wood drill (or maybe a nail or something) to mark the center of the hole. Or use the 15 mm jig to mark the 15 mm hole directly.
| 15mm_Jig.STL | 1.8MB | |
| 3mm_Jig.STL | 1.8MB | |
| SoapDispenserLid.STL | 453.0KB |
