Wall mount for a Sabrent 16-port USB hub. Designed to use short door hinge screws but anything with a roughly shaped head will work. In my case I was mounting to a 3/4" sheet of plywood clamped to a free-standing shelf. There are two pieces with the bottom having a cutout for the cords and holes to fit a standard phillips bit in to get to the screws and the top just requiring a little finesse to angle the bit/screw. You will need to remove the rubber feet from the hub.
Best to mount the bottom piece level, insert the hub, then add the top piece and outline where it goes. Remove everything and mount the top piece. Slide the hub through the top and press every button on the way down to get past them.
This 1st version works but needs improvement. I designed dimensions with a hair of wiggle room though it becomes not enough unless you get a countersink bit and really open up the screw holes enough so that your screw-head can sit flush on the inside. As it is I was just barely able to get the hub slid through with a lot of wiggling.
| sabrent_usb_hub_mount_v2.stl | 3.0MB |
