Sabot 120 Mm 3D Printer Model
The file 'Sabot 120 Mm 3D Printer Model' is (pdf,stl) file type, size is 790.2KB.
The file 'Sabot 120 Mm 3D Printer Model' is (pdf,stl) file type, size is 790.2KB.
I have designed a 1:1 replica of the 120 mm SABOT, which has a height of approximately 1018 mm. A detailed PDF with dimensions is attached for your reference.
To assemble, you will need to glue the pieces together. You might also need a rubber band for the top of the SABOT to hold the pieces in place. Although I haven't tested the SABOT and penetrator yet, the tolerances should ensure a proper fit.
Some pieces have been given additional tolerance to improve the fit. In the worst-case scenario, minor sanding might be required.
It may not be accurate 100% this piece, because some pieces had been optimized for better print orientation requiring less support or sanding.
It can fit in an Ender 3 v2
I hope you like it! :D
| 120mm_SABOT_LaMakina3D.pdf | 207.3KB | |
| Bottom_Coin.stl | 240.7KB | |
| HexPin_x3.stl | 7.9KB | |
| Penetrator_Bottom.stl | 290.9KB | |
| Penetrator_Middle.stl | 1.6MB | |
| Penetrator_Middle_2.stl | 1.6MB | |
| Penetrator_Top.stl | 211.2KB | |
| Primer.stl | 481.5KB | |
| Sabot_Bottom_x3.stl | 1004.0KB | |
| Sabot_Top_x3.stl | 1.2MB | |
| Shell_A.stl | 1.9MB | |
| Shell_B.stl | 436.6KB | |
| Shell_C.stl | 437.1KB | |
| Shell_D.stl | 404.6KB | |
| Shell_E.stl | 391.3KB | |
| Wing_x6.stl | 30.8KB |
