Ryobi ONE+ Wall-Mount Battery Holder 3D Printer Model
The file 'Ryobi ONE+ Wall-Mount Battery Holder 3D Printer Model' is (stl) file type, size is 120.32 KB.
The file 'Ryobi ONE+ Wall-Mount Battery Holder 3D Printer Model' is (stl) file type, size is 120.32 KB.
Owning a number of Ryobi ONE+ tools and batteries, and being disappointed at the available options for storing our extra batteries, we came up with this design.
For best results, support material should be used on the area where the battery clips mate with the holder (see photos).
We used honeycomb infill at about 30-40% to make sure the part would be very sturdy and feel strong and heavy, and because these are the settings that help us minimize shrinkage cracking with our plastic and printer, but the design should hold up even with minimal infill (15-20%).
The model shown was printed in red ASA (similar to ABS) and finished by hand with acetone and 400-through-1000 grit sandpaper. This is not necessary to make the part functional, we just wanted it to look pretty.
| RYOBI_Battery_Mount_v4.STL |
