IMPORTANT UPDATE.. i just uploaded a patched cylinder that had a thin shell is some places fixed now,, AMMO size fixed too.. so now it fits tighter and not so loose and nosey.. so should print with no problems.. sorry for any issues,, the original printed ok on my printer but i saw it to thin in some areas so i repaired :D
thanks for the original files,, from there i added an ammo door and pin on the left side of the hammer like a real firearm,, so ammo is removable and you can load your own selections at random
i slimmed the complete sword so not so thick, the length the same.. i shortened the cylinder to closer match to the screen shots.. i resized it all at once so all will still fit good together, just the center rod is smaller approx 2cm width..
i did my best, i am printing it now,, at 0.1 layers in blue glow in the dark.. i using 0.3 tip.. the cylinder takes the longest,, approx 32 hours :( so better use 0.2 layers heheha
| ammo_door.stl | 207.9KB | |
| ammo_door_pin.stl | 10.8KB | |
| ammo_size_fixed.stl | 21.2KB | |
| blade_2nd_bottom.stl | 27.3KB | |
| blade_3rd_bottom.stl | 34.0KB | |
| blade_bottom.stl | 35.7KB | |
| blade_pointed_tip.stl | 57.0KB | |
| blade_tip_2nd_from_top.stl | 11.7KB | |
| blade_tip_3rd_from_top.stl | 23.3KB | |
| blade_tip_4th_from_top.stl | 22.2KB | |
| bottom_brace_x4.stl | 422.2KB | |
| center_brace_x4.stl | 104.5KB | |
| cyliner.stl | 907.9KB | |
| cyliner_wall_thickness_patched_zero_point_one_five_min_thickness.stl | 16.3MB | |
| grip_bottom.stl | 1.2MB | |
| grip_top.stl | 1.1MB | |
| handle_center_rod_Cut_1.stl | 2.0MB | |
| handle_center_rod_Cut_2.stl | 3.7MB | |
| handle_center_rod_Cut_3.stl | 2.1MB | |
| handle_center_rod_Cut_4.stl | 1.8MB | |
| handle_top__ammo__loading_slot.stl | 865.9KB | |
| hilt_and_barrel.stl | 440.9KB | |
| pummel.stl | 87.6KB |
