Ruler Sliding Guide Clamps 3D Printer Model
The file 'Ruler Sliding Guide Clamps 3D Printer Model' is (stl,f3d) file type, size is 903.8KB.
The file 'Ruler Sliding Guide Clamps 3D Printer Model' is (stl,f3d) file type, size is 903.8KB.
These are designed to aid in making measurements with various rulers, in order to clamp you need to add some hardware.
Inside the slide is a spot to insert an M3 nut, I find it easiest to screw the nut into a bolt then press it in. to tighten you need to provide either a M3 bolt with a handle or an M3 thumbscrew (at least 6mm long bu preferrable 8mm).
NOTE: Over tightening will cause movement and scare the ruler, only use a hand tighten screw not a driven screw!
1/29/2018: Planning on adding some SAE versions of these along with some tweaks to the existing ones in the weeks to come.
2/3/2018: Added SAE versions with 4-40 and 6-32 nut inserts
| 1in_7_64in_4-40.stl | 26.4KB | |
| 1in_7_64in_6-32.stl | 26.4KB | |
| 1_2in_7_64in_4-40.stl | 25.5KB | |
| 1_2in_7_64in_6-32.stl | 25.5KB | |
| 1_3mm.stl | 42.5KB | |
| 1_4in_1_16in_4-40.stl | 26.4KB | |
| 1_4in_1_16in_6-32.stl | 26.4KB | |
| 1_4in_7_64in_4-40.stl | 26.4KB | |
| 1_4in_7_64in_6-32.stl | 26.4KB | |
| 25_2mm.stl | 26.4KB | |
| 25_3mm.stl | 42.1KB | |
| 2in_17_128in_4-40.stl | 24.9KB | |
| 2in_17_128in_6-32.stl | 24.9KB | |
| 2in_7_64in_4-40.stl | 24.9KB | |
| 2in_7_64in_6-32.stl | 24.9KB | |
| 2_3mm.stl | 39.1KB | |
| 2_4mm.stl | 39.1KB | |
| 5_3mm.stl | 40.1KB | |
| Measure_Base_Slider_1-25_3mm_v5.f3d | 164.5KB | |
| Measure_Base_Slider_1-5_3mm_v4.f3d | 159.1KB | |
| Measure_Base_Slider_1_3mm_v2_v6.f3d | 160.4KB | |
| Measure_Base_Slider_2_3mm_v7.f3d | 155.6KB | |
| Measure_Base_Slider_2_4mm_v2.f3d | 156.0KB |
