Rugged Box For FNIRSI HS-01 Soldering Iron And Poweradd 100w Power Bank 3D Printer Model
The file 'Rugged Box For FNIRSI HS-01 Soldering Iron And Poweradd 100w Power Bank 3D Printer Model' is (stl) file type, size is 376.9KB.
The file 'Rugged Box For FNIRSI HS-01 Soldering Iron And Poweradd 100w Power Bank 3D Printer Model' is (stl) file type, size is 376.9KB.
This is a box for a Fnirsi HS-01 soldering iron and the 100W USB C power bank from poweradd.
For about 40 bugs it's one of the cheapest smart USB soldering irons out there and it heats up great. Actually quiet comparable to my WELLER PU81, but way smaller.
Together with that power bank you can have a soldering kit for on the go for under 100€.
The middle hole that's currently empty is intended for brass whool, because I don't want to have a wet sponge near my power bank in my water resistant box.
I used some spare builders silicone for the seal. I think it should be able to resist a bit of splashing, while guerrilla soldering.
This is based on this rugged parametric box design.
https://www.printables.com/de/model/258431-rugged-box-parametric
I changed it's size and constructed the inlay
| Box_-_Bottom.stl | 431.1KB | |
| Box_-_Latch_1.stl | 185.3KB | |
| Box_-_Lid.stl | 408.3KB | |
| Oberseite.stl | 177.6KB | |
| Unterseite.stl | 405.6KB |
