Rubber Band Powered Car 3D Printer Model
The file 'Rubber Band Powered Car 3D Printer Model' is (STL) file type, size is 362.8KB.
The file 'Rubber Band Powered Car 3D Printer Model' is (STL) file type, size is 362.8KB.
This is one of the three series of rubber band powered that I have made. There are two photo attachment of the previous version of the model.
Until this model is printed, the obstacles that I face is that I get all four wheels are angled hole, or holes not perpendicular and make wheel shake when turning. And the upper part of the body is too high causes a nut and bolt holes slightly shifted due to swaying during printing.
This material you need:
| car_5_-_body.STL | 269.2KB | |
| car_5_-_holder.STL | 57.3KB | |
| car_5_-_propeller_-_front.STL | 268.9KB | |
| car_5_-_propeller_-_rear.STL | 292.1KB | |
| car_5_-_wheel.STL | 56.3KB | |
| car_5_-_wing.STL | 41.3KB |
