Rubber Band Powered Boat 3D Printer Model
The file 'Rubber Band Powered Boat 3D Printer Model' is (STL) file type, size is 397.2KB.
The file 'Rubber Band Powered Boat 3D Printer Model' is (STL) file type, size is 397.2KB.
This boat is one of three of the models using a rubber band that I created after a few tries and I tried to put weight on it by using coins and weighing approximately 32.77 grams (https://www.youtube.com/watch?v=fsYgb2xobzQ).
Website address of this model comes from this address: http://blog-imgs-49.fc2.com/b/o/a/boat328/Boat-Blue-Prints-3.jpg, then I cut it a little so that the flat part and can be printed, the middle there are 2 pieces of support that can be broken also to reduce the weight of the boat, and the inside of the boat is made does not fit contours and has a 50-degree angle.
Beside this model there is a pipe with a thickness of 0.5 mm so useful when printing "boat engine" is not twisted.
The concept of this boat using a model boat with outboard engine, after I saw some pictures on the internet if the propellers how under the hull and slightly backward.
Without coins: https://www.youtube.com/watch?v=dP6Yn2Cyz8U&feature=youtu.be
https://vydesyl.wordpress.com/2012/08/30/boat-building-with-wooden-boat-blueprints/
| boat.STL | 610.5KB | |
| boat_-_propeller.STL | 330.0KB |
