Rovyvon E8 Tail Clip Magnet Attachment 3D Printer Model
The file 'Rovyvon E8 Tail Clip Magnet Attachment 3D Printer Model' is (stl) file type, size is 215.2KB.
The file 'Rovyvon E8 Tail Clip Magnet Attachment 3D Printer Model' is (stl) file type, size is 215.2KB.
Tail clip for the Rovyvon E8 Angel Eyes to hold a magnet. I used an "11.4mm x 11,4mm x 4.7mm" magnet in this project.
The measurements were made really tight for a better hold, so you will have to push the magnet in the model while still hot. If you want to use a smaller magnet, use hot glue or design an adapter part.
The tail clip will fit just right in the flashlight. There is a pass-through hole in the widest part for you to put a pin to hold in place. The pin can be made of a cotton swab or you can print it yourself.
| EN8_Magnet.stl | 2.0MB |
