Rotating USB Drive / Flash / SD Card Desktop Storage 3D Printer Model
The file 'Rotating USB Drive / Flash / SD Card Desktop Storage 3D Printer Model' is (stl) file type, size is 783.3KB.
The file 'Rotating USB Drive / Flash / SD Card Desktop Storage 3D Printer Model' is (stl) file type, size is 783.3KB.
This is a rotating desktop flash storage holder. It has a rotary hub design with a base that the top part rotates on. This is done with a 8mm x 22mm x 7mm bearing (608ZZ) in the base, and 2cm of 8mm (M8) threaded rod in the top part for the axle. Use a bit of teflon tape on the threaded rod if its not spinning smoothly.
This holds 16 usb sticks (8 large, 8 smaller), 8 SD cards, 20 micro-SD
Print using regular/default settings for PLA and it should print fine with no supports.
ADDITIONAL ITEMS NEEDED:
1x 8mm x 22mm x 7mm bearing (608ZZ)
1x 8mm (M8) threaded rod (at least 2 cm)
| ultra-flash-storage-base_v2.stl | 123.8KB | |
| ultra-flash-storage2.stl | 1.8MB |
