This is the dual spool holder setup for Rostock Max v2. It works brilliant, and spins great with the 608zz bearings on a M8 threaded rod.
Instructions:
We used 30% innfill for all of the items. Works great. Printed in PLA+ . Tolerances for where the bearings goes is tight. Needs to be knocked in. If you find it hard to measure where to drill the holes for the funnel, just print the funnel guide plate. To mount the base plate you need to unassamble the spool holder. Its a tight fit, bit it will go in there. The tight fit is needed to stop it from wiggeling. Use a M2 screw & nut to secure it on place. For the nut finishers, use some superglue and glue the nuts to the finishers.
Accessories needed:
M8 threaded rod (1x cut to: 320mm)
M8 nuts (2x (lock-nuts if you have))
608zz bearings or simular sized ones. (4x , 2 on each roller)
M2x16mm screw and nut
Print Qty:
1x off all the not listed files
2x Roller_v2.stl
2x nut_finisher_v2.stl
3x washer_for_bearing_clearance.stl
This spool holder also works as a solo spool holder. You need a shorter M8 rod, 1x roller, 2x washer_for_bearing_clearance.stl.
Funnel:
m3 shcs or simular m3 screws (4x)
m3 nuts (4x)
| extender.stl | 160.6KB | |
| funnel_drill_guide.stl | 81.4KB | |
| funnel_left_v2.stl | 585.4KB | |
| Funnel_right_v2.stl | 597.0KB | |
| nut_finisher_v2.stl | 282.5KB | |
| Roller_v2.stl | 279.5KB | |
| spoolh_base_v2.stl | 829.2KB | |
| washer_for_bearing_clearance.stl | 435.3KB |
