this is something i threw together real quick. 2 candle holders. these were printed with madesolid pet+ then airbrushed and faux finished to give a semi rusted old metal appearance. the rope is 3/8" natural sisal available right at home depot. the ends of the rope are glued in place with a little epoxy to keep it from unwinding. once the rope is on burn the hairs off with a small torch or lighter so its not so fuzzy and to give the rope a slight aged look. submerse the candle holder and rope in water for about an hour then take it out and let it dry. the rope will shrink up a little and get even tighter around the holder. there is a cap file. this piece goes under the candle. you can fill the inside with sand or something heavy if you want then put the cap on and glue in place or even leave it empty then you can use it for a secret hiding place.
| candleholderlg.stl | 4.2MB | |
| candleholdersm.stl | 3.9MB | |
| holdercap.stl | 45.4KB |
