No glue needed Rool Top Box.
It just snaps together, and your done!
These assemble in seconds. Super Easy Print.
Box has two tabs to lock together.
The lid should be printed in TPU/PLA or all pla. I would print the first two layers in TPU, then change filament to PLA and let the print finish. Fill at 30%.
Body prints in two pieces which have tight tolerances. Print anyway you like but use a .2mm layer height.
Body and side B print in 4-5 hrs @ 60 mm/s @ .2mm layers @ 15 % fill
Lids prints in 40 min.
https://www.youtube.com/watch?v=saRuymPIdl8
| Sliding_Box_Main_Body__LOCKING_REV_B.STL | 127.2KB | |
| Sliding_Box_Side_B_LOCKING_REV_B.STL | 75.7KB | |
| Sliding_Door_1mm_th.STL | 45.0KB | |
| Sliding_Door_2.STL | 43.8KB |
