Axis locks for RONIN-S.
https://youtube.com/shorts/6XdkOBWnCwM
Since the Ronin S doesn't have axis locks, I decided to make my own so that they could be permanently on the gimbal and the axes could be locked and unlocked with the click of a button (just like other, newer Ronin models).
After printing (I recommend printing from ABS) slide the LOCK part into place in the appropriate btm part and then snap both btm parts and both top parts of each axis together directly on the gimbal (use reasonable force). To keep the parts in place afterwards, use a few drops of acetone or instant glue on the snap joints and the contact surface of the rings and gimbal, or use thin double-sided adhesive tape on the contact surface. Especially on the PAN axis, this is necessary so that the btm parts do not rotate.
When gluing in place, make sure that there is about 0.5 - 1 mm of space between the two rings and that the axes can rotate freely when the lock is unlocked. Try it dry first, then glue! Be aware that using acetone or glue can leave marks on the gimbal itself and too much can damage the gimbal! Use only at your own risk.
| LOCK.stl | 60.0KB | |
| PAN_axis_btm1.stl | 172.3KB | |
| PAN_axis_btm2.stl | 161.3KB | |
| PAN_axis_top1.stl | 145.3KB | |
| PAN_axis_top2.stl | 144.9KB | |
| TILT_ROLL_axis_btm1.stl | 197.3KB | |
| TILT_ROLL_axis_btm2.stl | 185.9KB | |
| TILT_ROLL_axis_top1.stl | 145.6KB | |
| TILT_ROLL_axis_top2.stl | 144.9KB |
