Wanted a knife sharpenner that was effective but didn't want to pay through the nose for it...
Requires the following hardware:
2x M5x40 Countersunk Screws
2x 608ZZ Bearings
1x 33x6mm magnet with 4mm countersunk holes
1x M4x20 screw (longer is better as the magnet is STRONG)
2x wetstones: https://www.amazon.com/dp/B0BS15JR3L?psc=1&ref=ppx_yo2ov_dt_b_product_details
2x rubber bands
Recommend printing in PETG
| 608ZZ_Bearing_v2.step | 24.8KB | |
| Angled_Block_v1.step | 1.2MB | |
| Angled_Block_v1.stl | 900.7KB | |
| Assembly_v6.step | 2.2MB | |
| Axle_v2.step | 1.6MB | |
| Axle_v2.stl | 1.7MB | |
| Drum_v4.step | 46.3KB | |
| Drum_v4.stl | 1.0MB | |
| Wetstone_Cap_v1.step | 262.1KB | |
| Wetstone_Cap_v1.stl | 919.6KB | |
| WetStone_Carriage_v3.step | 281.4KB | |
| WetStone_Carriage_v3.stl | 528.3KB | |
| Wet_Stone_v1.step | 7.6KB |
