Version 2 (V2)
I made a smaller version, so now it fits smaller spool holder holes.
It fits as low as a internal spool holder diameter of 56mm
If you like my designs, please support me. Even $1 is fine :) paypal.me/bmabma
The original spool holder of Creality Ender 3 has a diameter (30mm) too small in comparison to the spools i've been using (74mm) so I did this support.
There are 2 supports that are clamped to the original spool holder, and each one has 2 rolls on the top that make contact with the spool. No need to use bearings, bolts nor any extra part, just print it!
I used 0.2mm of layer height, 0.20 infill and tree supports
You need to print:
| Roll_support_for_spools_-_Ender_3_-_CLAMP.stl | 147.4KB | |
| Roll_support_for_spools_-_Ender_3_-_ROLL.stl | 497.5KB | |
| V2_Roll_Support_for_Spool_Ender_3_-_clamp.stl | 970.7KB | |
| V2_Roll_Support_for_Spool_Ender_3_-_roll_cylinder.stl | 489.9KB |
