Rod And Tube Cutter For Dremel 3D Printer Model
The file 'Rod And Tube Cutter For Dremel 3D Printer Model' is (stl,step) file type, size is 1.2 MB.
The file 'Rod And Tube Cutter For Dremel 3D Printer Model' is (stl,step) file type, size is 1.2 MB.
This is a tool to cut small diameter rods or tubes using a Dremel. I use it with a Dremel 395. It has the Dremel thread (M18x2,25/ANSI 3/4-12) in the guide part, so you can just easily screw the Dremel in. You will need a small tube or rod with a 10mm diameter to connect the two parts. The guide part might need some sanding to fit in the base, I wanted it to fit nicely with little play.
I also made a non-metric version for the hinge. You can use a 3/8" axle for the hinge instead of the 10mm axle. The files with "_38" in the filename are the 3/8" axle version. I hope the tolerances are okay to fit the axle in.
Also added a support-block, for supporting the loose end of the tube/rod to be cut.
EDIT 2019/01/26
I added the .step files for the 3/8" hinge version, so everyone is free to make their own mods.
EDIT 2019/02/04
Modified the base part, so the flex guide part would not collide anymore with the base. Since I don't have the flexible extension for the Dremel, I cannot test the flex guide part.
If you are using the regular guide or guide_38 part you are fine, nothing to change.
| Base.stl |
| Basis_38.stl |
| Dremel_Rod_Cutter_38.step |
| Guide.stl |
| Guide_38.stl |
| Guide_38_Flex.step |
| Guide_38_flex.stl |
| Support_V-Block.stl |
