This was designed based on the Green solo fret button for the Rockband 3 guitar.
Here are the length dimensions for the other solo fret buttons (all the same width):
Red: 44.4mm
Yellow: 45 mm
Blue: 45.6mm
Orange: 46mm
It includes a slot for stabilizers if you want to create them yourselves (I used a 1mm diameter brass rod I bought from Aliexpress)
I recommend rotating the model 90 degrees on the X axis to get a smooth wall on the top of the button.
Also hide the 3D printer "starting" points on the non-visible side of the button.
My mission is to make these guitars / drum kits serviceable again via 3D printing!
Feel free to tip if you like!
| rockband_solo_frets_v1.stl | 103.2KB |
