Robot B9 (Lost In Space) 3D Printer Model
The file 'Robot B9 (Lost In Space) 3D Printer Model' is (stl,blend,ctb) file type, size is 123.0MB.
The file 'Robot B9 (Lost In Space) 3D Printer Model' is (stl,blend,ctb) file type, size is 123.0MB.
The robot from the early series of Lost in Space Never had a real name,
but was just known as robot
I have added a blend file that as all the separate parts for your manipulation and printing,
the stl files provided should allow you to print them in larger sections
1 CTB file for a elegoo printer to print a 140mm robot
a couple of issues with the print, don't print the body too close to the bed,
the legs seem to of gained a membrane on the inside, will just need removing
ensure the arms are well supported
I had a small lift on one side of one of the arms
Luckily not to detrimental
a little sandpaper may be needed to thin the claw bases to fit the slots in the arms
a new added body option with reinforced front plate, a base plate to aid adhesion for printing without supports, also a drain hole to help, and separate top
| arm_Left__contoured.stl | 465.6KB | |
| arm_Right__contoured.stl | 490.1KB | |
| body_Top_Buttons_arms_section.blend | 14.8MB | |
| BODY__top_buttons_arm_sections_1.stl | 10.1MB | |
| Claw.blend | 882.8KB | |
| Claw.stl | 33.5KB | |
| Finished_Leg_section.blend | 7.5MB | |
| Finished_leg_section.stl | 4.2MB | |
| Foot_section.blend | 5.5MB | |
| foot_section.stl | 3.6MB | |
| Robot.ctb | 85.2MB | |
| Robot_complete_with_arms.blend | 27.0MB | |
| Robot_complete_with_arms.stl | 18.6MB | |
| z_Body_with__drain_hole.stl | 14.9MB | |
| z_Top_cap.stl | 234.5KB |
