Robo3d R1 Z Axis Bearing Stabilizer 3D Printer Model
The file 'Robo3d R1 Z Axis Bearing Stabilizer 3D Printer Model' is (stl) file type, size is 95.9KB.
The file 'Robo3d R1 Z Axis Bearing Stabilizer 3D Printer Model' is (stl) file type, size is 95.9KB.
So I made a Z Stabilizer that uses a 608ZZ 8x22x7 Shielded Greased Miniature Ball Bearings. I tried to make something different because every z stabilizer i make would always catch the threaded rod and bind it up. I did sand the inside to clean up the stragglers and make it easier to fit the bearings.
Make both of them. I printed them without support at a 25 infill PLA. I used two sided stick pads to mount to inside double sided tape could work to. The right side on mine had more of a gap and was a bit of a pain getting correct gap length but should be good let me know your thoughts.
| Z_Axis_Bearing_Both.stl | 183.3KB | |
| Z_Axis_Bearing_Left.stl | 91.7KB | |
| Z_Axis_Bearing_Right.stl | 91.7KB |
