Fixed some things i didnt like about the original carriage / extruder expecially mounting a E3d V6 . The screws that deform the E3d to lock it in is a bad idea imo .It deforms the hotend metal (bad),eventually destroys the hotend if reinstalling multiple times, the hot end always ends up crooked etc . So i created a new Carriage and extruder so the hotend slides into the carriage and tightening the extruder to lock it in. You do lose a few mm in z travel since the hotend sits lower and carriage is thicker but thats trivial.

Also upgraded on the carriage is a new x belt mount design .This allows some tension adjustment by way of adjustable 3mm screw tnut slot . The carriage accommodates a Tslot fan mount on the back . 40mm screwless Fan mount also included in files designed specifically for this carriage.

ADDED: STL for Carriage specifically for Hexagon Hot end . Uses same extruder STL .Difference between other carriage is this one has a mounting depth 1mm shorter for the hex shorter lenght heatsink groove.

The extruder is specifically designed for this new carriage . Hotend hole specs made for the E3D V6 . Added a ziptie tab to hold wires.

Fitment: The fan tslot needed a litle post process sanding to slide into the carriage easily.You can modify the solidworks file and make the tslot slightly small to avoid and post processij. The LM8UU bearing fit nicely in the carriage .Just put it in a vice and it pops in witth minimal force.

REVISIONS: 3/15/16 Fixed the fan tslot issue . New file _tslotADJ
REVISIONS 4/3/16 Added files for WadesHeX extruder and HexCarriage
Added 4/27/16 : Herringbone gears i use with this setup
REVISION2 10/7/2017 E3D Carriage belt tensioner and Tnut upgrade (HARDWARE NEEDED 1x 3mmx6mmL screw ,washer and 1x 3mm Nut )

If you like the part , please donate .Thanks :)