This is my first attempt at designing a part so it is a work in progress. I have a RIGID case with my FT-857D mounted in it. My RigExpert AA-54 was held in by velcro so I designed this bracket to hold it in place. I printed in PLA as that's all I've used at this point and everything seems to fit. Something a little less brittle may be better.
I am holding it in place inside the case with 3M VHB.
If you print it or have any suggestions on how to improve it I would be glad to hear them, I'm just learning all of this.
| RigExpert_v8.123dx | 63.6KB | |
| RigExpert_v8_filet.123dx | 97.7KB | |
| RigExpert_v8_Final.stl | 1.2MB |
