This was designed around the Ridgid Blower. Very similar to the Mikiata ones with key differences.
Design Constraints:
• Ridgid blower inlet had a 43mm diameter. Edges around it rise up 6mm, so the keyed pegs will need to clear this
○ Outlet is 40mm. With center of locking holes 8mm off the flush edge. Holes are 7mm tight fit wide. Hole channel is 7mm-8mm.
○ Outlet length is 29-30mm long.
End of long nozzle attachment is 35mm inner diameter. This design does not use this piece.
| Ridgid_Leafield_D7_C7_Blower_Nozzle.dwg | 995.8KB | |
| Ridgid_Leafield_D7_C7_Blower_Nozzle.stl | 49.0KB |
