Rick And Morty Coaster 3D Printer Model
The file 'Rick And Morty Coaster 3D Printer Model' is (stl) file type, size is 434.8KB.
The file 'Rick And Morty Coaster 3D Printer Model' is (stl) file type, size is 434.8KB.
A three piece Rick and Morty drinks coaster for your office desk.
I printed the center insert face down on a glass bed (made it nice & shiny). A small drop of glue holds in place on the base.
I printed the outer ring using Z-hop when retracted & retract only over printed parts both switched on. This prevented any scars on the lower grooves due to the nozzle dragging over the surface (happened on the first time printing). I also set the top layer line direction to match the upper groove direction to make the top look cleaner (ironing top layer only is also a good option).
The base has four 21mm wide & approx 2.1mm deep inserts underneath to accept 20mm x 3mm furniture feet pads for a soft contact with whatever surface the coaster is placed on (I found some great sticky back ones in my local hardware). These can be ignored & simply left empty if you wish. Bridging settings can be used but I didn't activate them & it printed just fine (fan was at 100% by the time these sections were bridged).
| Base_Large.stl | 483.1KB | |
| Insert_Thin.stl | 894.8KB | |
| Ring_Large.stl | 84.6KB |
