The file 'Reptile Mealworm Feeder For Holiday 3D Printer Model' is (stl) file type, size is 9.7KB.
This is a feeder for your reptiles, especially geckos. I use it if i am on my holidays and can not feed them everyday. It is very useful also for baby geckos. You just put the mealworms or half mealworms (in case you use it for baby geckos) into the tube and then turn the tube around and insert it into the base. Now the mealworms slowly fall out of the tube into the triangle piece and can be eaten by the reptiles. Also the mealworms can not escape because of the 1cm high walls. Although there are little tanks on the sides wich you can fill with sand so the feeder will not fall over. You can close the tanks with the little plugs so no sand will flow out.
I will upload pictures as soon as possible.
For this thing you will need:
1x base
1x tube
2x plug
If you have any questions comment down below.
base.stl | 80.9KB | |
plug.stl | 24.6KB | |
tube.stl | 24.1KB |