Replicator 2X Bearing Block 3D Printer Model
The file 'Replicator 2X Bearing Block 3D Printer Model' is (STL) file type, size is 11.8MB.
The file 'Replicator 2X Bearing Block 3D Printer Model' is (STL) file type, size is 11.8MB.
This is the left hand bearing block for a Replicator 2X.
Mine wore out where the pulley shaft meets the block, so I decided to print one on my Taz 6
The slip bearings are held in place with a rubber O-Ring. I will be adding a retainer plate to both ends to help secure the bearing in its seat.
Designed with Solid Works.
Update: 10/06/2016Revision 1.1
The offset between the timing belt clamps was off.
I changed the offeset for the timing belt clamps
Also made the clamps a bit thicker for rigidness...
Rev. 1.2
Just cleaned some edges up and beefed up the belt clamps
| Makerbot2_XY_Bearing_Block_Rev1.1.STL | 4.1MB | |
| Makerbot2_XY_Bearing_Block_Rev1.2.STL | 9.0MB | |
| Makerbot_Rep2_XY_Bearing_Block_Rev1.0.STL | 19.3MB |
