Replacement Pedal Switch Rubber Plug (Looper Etc) For Guitar FX Pedal Korg AX1000G 3D Printer Model
The file 'Replacement Pedal Switch Rubber Plug (Looper Etc) For Guitar FX Pedal Korg AX1000G 3D Printer Model' is (stl) file type, size is 44.0KB.
The file 'Replacement Pedal Switch Rubber Plug (Looper Etc) For Guitar FX Pedal Korg AX1000G 3D Printer Model' is (stl) file type, size is 44.0KB.
This is a repair part for The Korg ToneWorks AX1000G guitar effects pedal.
The pedal has a mini-switch on the top that registers if the foot pedal is pressed all the way, which is used for starting/stopping the sample+play function.
The rubber plug/grommet that engages the microswitch can wear off or break.
This part should replace it well enough. It is a rough draft, and might need some filing or scaling to fit easily.
You might have to (carefully!) push it into the pedals' receptacle with a vice or similar, but if you print with 20-40% infill the plug should be flexible enough to be pushed in.
Afterwards, check if the plug engages not too early / or too late / not at all with the microswitch.
The interaction with the microswitch can be adjusted by scaling the length of the plug.
| Guitar_Pedal_Knob_AX100G_v4.stl | 180.1KB |
