Updated
After a bit I discovered that the doors were rotating in the 'closed' position and falling out a bit. Trimming made them looser. I could use a magnet (drill little hole in both sides to help hold them shut in the right spot), but I decided that rotating the hinge snaps might work. So this has the ends of the hinges rotated 90 degrees. Old doors are in a .zip in case those worked better for you.
More Drop Pod Stuff
See my full drop pod (http://www.thingiverse.com/thing:446893), which is overly complete! I'll try to post a pix in a bit.
Thanks
Thanks a TON to Kushan77 and outofstep!
This one has some greeblies/detail to try to make it a little more fun.
Print on high (.1mm) to get the most detail. I print on supports (no raft), with the interior side facing the bed, and then leave a bit of the rafts on the model, which kind of makes it look a little like tread.
Please support my projects
In case you haven't seen my full size Lego R2-D2, check out L3-G0 @ http://L3-G0.com or http://youtube.com/myL3G0 - If you like my projects, please tweet or share, every bit helps, thanks! If you build one, please post a pix in the "I made one"
| About_Hinge_Angle_of_Doors.txt | 544.0B | |
| Drop_Pod_Assembly_-_Closed.stl | 3.4MB | |
| Drop_Pod_Assembly_-_Opened.stl | 3.4MB | |
| Drop_Pod_Door.skp | 1.4MB | |
| Drop_Pod_Door.stl | 139.4KB | |
| Drop_Pod_Door_-_Plain.stl | 73.8KB | |
| Drop_Pod_Door_-_Totally_Blank.skp | 1.2MB | |
| Drop_Pod_Door_-_Totally_Blank.stl | 40.3KB | |
| Old_Hinge_Angle.zip | 1.3MB |
