I added a snap-fit connection to both parts of the case, (screw or glue still needed), and updated the joystick and its base. I also chose to use springs over the posts/under the buttons, where the rubberband would normally go, but that required no modification to that particular part of the model.
Kudos to Jaatinen3D, the original designer of this model! It's honestly one of my favorite fidget toys. Beautiful model!
| Case_REMIX_v2.stl | 1.2MB | |
| REMIXED_Joystick_Larger_v2.stl | 855.8KB | |
| Toy_Controller_-_Button_1.stl | 2.0MB | |
| Toy_Controller_-_Roller.stl | 42.3KB | |
| Toy_Controller_-_Roller_Axle.stl | 28.2KB | |
| Toy_Controller_-_Shoulder_Button_Left.stl | 790.7KB | |
| Toy_Controller_-_Shoulder_Button_Right.stl | 790.6KB | |
| Toy_Controller_-_Shoulder_Spring.stl | 30.6KB | |
| Toy_Controller_-_Slider_Knob.stl | 562.6KB |
