Remix Of Self Locking Kossel Mini Carriage With Variable Beltway Width 3D Printer Model
The file 'Remix Of Self Locking Kossel Mini Carriage With Variable Beltway Width 3D Printer Model' is (stl,scad) file type, size is 87.3KB.
The file 'Remix Of Self Locking Kossel Mini Carriage With Variable Beltway Width 3D Printer Model' is (stl,scad) file type, size is 87.3KB.
I like these self locking belt clamps, but 2.5mm works better for me than the original 2.2mm.
I am using this on a Folger Tech Kossel 2020 & used the geometry from my previous remix http://www.thingiverse.com/thing:1793640 & used the self locking belt clamp idea from http://www.thingiverse.com/thing:556178
I made the nut trap for the locknuts so they are easier to insert without going thru the beltway. There is also a small hole on the bottom of each nut trap to make it easier to eject the locknut with a small allen wrench if you need to take the locknut out.
There are a few variables in the openscad file you can change, but the main 2 variables you might change are:
Gap_Tighten_Wid = 2.5; //2.2 was the original size
Lt_Rt_Both = -1; //-1 = Left Bottom Mount Hole Only
//0 = Both Left & Right Mount holes
//1 = Right Bottom Mount Hole Only
I printed this with eSun PLA+ Silver at 50% infill.
| SelfLockCarriage_2_5Gap_Both_Rev46.stl | 129.9KB | |
| SelfLockCarriage_2_5Gap_Left_Rev46.stl | 118.7KB | |
| SelfLockCarriage_2_5Gap_Right_Rev46.stl | 118.7KB | |
| SelfLockCarriage_Rev46.scad | 6.7KB |
