Red Hood Inspired Mandalorian Helmet 3D Printer Model
The file 'Red Hood Inspired Mandalorian Helmet 3D Printer Model' is (stl) file type, size is 8.0MB.
The file 'Red Hood Inspired Mandalorian Helmet 3D Printer Model' is (stl) file type, size is 8.0MB.
Created this mesh-up of the Red Hood and Mandalorian helmet for cosplaying.
All credit to the original designers of the material used.
Also credit to NZ cosplayer Brock Harper for the idea to make this mesh-up, hope you can use it in the costume you want to create.
I am by no means any good with 3d modelers and used Tinkercad to create this remix. Due to this I needed to lower the Poly mesh of the models used to be able to use is in Tinkercad.
Also the Model is pretty rough on the inside and there will be a couple of flaws, but this can be improved with foam padding after printing and painting.
The split up pieces for smaller printers will make a helmet of 110% of the full complete model. I did this because I am concerned about the helmet fitting over the head of adult male and still be comfortable, and I am not making a test print to check.
Also you will have to scale the tubes up to 110%
I am able to fit the full helmet at 108% on my Ender 3 Max when leveling it out and turning it 45 degrees diagonally on the build place.
Might be a trial and error situation but should be close.
There is also a front and back model if you are able to fit larger pieces on your build plate.
Good luck
| Bottom_L-front.stl | 682.1KB | |
| Bottom_L-rear.stl | 1.0MB | |
| Bottom_R-front.stl | 676.4KB | |
| Bottom_R-rear.stl | 1.0MB | |
| Red_Hood_inspired_Mandalorian_Helmet_complete.stl | 4.4MB | |
| Red_Hood_Mando_mask_back.stl | 2.2MB | |
| Red_Hood_Mando_Mask_Front.stl | 2.2MB | |
| Top_L-front.stl | 276.2KB | |
| Top_L-rear.stl | 606.5KB | |
| Top_R-front.stl | 260.3KB | |
| Top_R-rear.stl | 575.9KB | |
| Tube-L.stl | 3.7MB |
