I'm planning a small toolbox build and love the look of machinist tool chests. I thought I'd try my hand at recreating the sweet ring pulls that a lot of them have. My goals were to simplify installation by streamlining the design while keeping the look clean.
This recessed ring pull uses no support and filament as the pivot pin between the ring and the recessed bezel.
Depth of assembled hardware is 3/8" (~9.5mm).
I also uploaded a metric version for all my friends in base 10! See post-printing for drill size/spacing.
bezel.stl | 1.1MB | |
bezel_metric.stl | 1.0MB | |
recessed_finger_pull.f3d | 296.1KB | |
Ring.stl | 318.1KB | |
Ring_metric.stl | 318.1KB |