Receiver Mount For Radiomaster RP4TD-M And Flywoo Explorer LR4 DJI O3 3D Printer Model
The file 'Receiver Mount For Radiomaster RP4TD-M And Flywoo Explorer LR4 DJI O3 3D Printer Model' is (stl) file type, size is 7.5KB.
The file 'Receiver Mount For Radiomaster RP4TD-M And Flywoo Explorer LR4 DJI O3 3D Printer Model' is (stl) file type, size is 7.5KB.
This is a simple mount to hold the Radiomaster RP4TD-M ELRS Receiver on the bottom of the Flywoo Explorer LR4.
It mounts using the DJI O3 bolt pattern so it can technically fit any frame that has 25.5x25.5 holes for the O3 VTX.
You'll need to pickup a longer (95mm) antenna as well if you want to run one to the front like I have. The standard short one will reach the back.
Make sure after you have the RX wired up and antennas connected that you shrink wrap it using the included clear heat shrink. Otherwise it'll be in direct contact with the carbon frame and bad electrical things could happen.
| RP4TDM.stl | 47.2KB |
