The Rear Fishing Rod Rack is intended to be used with the Front Fishing Rod Rack. The set of assemblies allow the user to mount fishing rods on their Tesla roof rack. The Fusion 360 file lists all additional hardware needed to use the racks. All steel hardware is recommended to be 316 stainless steel to prevent rust. All parts were printed using PETG except the ClampPads. These were printed using NinjaFlex.
In addition to transporting fishing rods on the Tesla, the Rear Fishing Rod Rack's two modular RodHolderWithM6HeatSetInserts may be used with the two LockRings, two FemaleBayonetConnectors and the CaddyBaseShortBidirect to mount fishing rod holders on your kayak assuming you have a compatible track mount system. A 3d printable YakTrackNut is provided for test-fit but the steel YakTrack nuts should be used to mount a fishing rod holder.
RearFishingRodRack v38.f3z updates the file FemaleBayonetConn.stl to properly recess the M6 bolts so that the bayonet connectors mate correctly.
| CaddyBaseShortBidirect.stl | 1.5MB | |
| ClampPad_v1.stl | 3.8KB | |
| FemaleBayonetConn.stl | 935.6KB | |
| FemaleBayonetToFemaleFrictionLock_v1.stl | 1.7MB | |
| LockRing.stl | 1.2MB | |
| MaleBayonet35ToMaleFrictionLock_v1.stl | 1.6MB | |
| RearFishingRodRack_v38.f3z | 11.1MB | |
| RearRodRackAndRodClampAndFemaleBayonets.stl | 5.2MB | |
| RearRodRackWithMaleBayonets.stl | 1.9MB | |
| RodClamp_v1.stl | 1.3MB | |
| RodHolderKnob_v1.stl | 2.2MB | |
| RodHoldersAndLockRingsAndKnob.stl | 10.0MB | |
| RodHolderWithM6HeatSetInserts.stl | 2.7MB | |
| WingKnob_v1.stl | 1.2MB | |
| YakTrackNut_v6.stl | 681.5KB |
