Rear Feet For HP3311A Signal Generator 3D Printer Model
The file 'Rear Feet For HP3311A Signal Generator 3D Printer Model' is (stl) file type, size is 23.6KB.
The file 'Rear Feet For HP3311A Signal Generator 3D Printer Model' is (stl) file type, size is 23.6KB.
Hewlett Packard made a nice little audio signal generator with sine/square/triangle wave output. It had molded feet on the bottom with a bail stand on the front. Unfortunately, the rear feet were made from some kind of plastic that became extremely brittle with time. I made the mistake of removing it when I thought that doing so would help me open the case. (It doesn't.) But it broke immediately. So I reconstructed it and printed a new one. A friend also has one with the rear feet missing, but no longer has the sleeve bushings that go through the holes. So I adapted the original with smaller holes to work with just the screws. So there are two files.
V2-1 has holes to fit the original bushings 1/4" diameter.
"-no bushings" has 3.75mm screw holes for use without the bushings.
Print it on one side and no supports are necessary.
| HP3311A_Rear_Foot_-_no_bushings.stl | 49.7KB | |
| HP3311a_Rear_Foot_v2-1.stl | 54.4KB |
