RD9000 RC Tank With FPV 3D Printer Model
The file 'RD9000 RC Tank With FPV 3D Printer Model' is (stl,docx) file type, size is 9.3MB.
The file 'RD9000 RC Tank With FPV 3D Printer Model' is (stl,docx) file type, size is 9.3MB.
Parts List:
Esun PLA Pro Filament
Sainsmart TPU Filament
5 x 11 x 4 Ball Bearings
3 x 10 x 4 Ball Bearings
M5 Hex Nuts
M5 Threaded Rods
M3 Screws of various lengths
M3 Hex Nuts
2205 to 2306, 1650 to 2350 kv RC drone motors
Electronic Speed Controllers
RC equipment to suit
Battery Pack to suit
All parts printed with 100% infill from Esun PLA Pro filament except the tracks which are printed from Sainsmart TPU at 100% infill. Ball bearings to be installed in each bearing pocket as designed. All 5mm shafts made from M5 threaded rods cut to length. Wheels and gears are driven by applying thread lock fluid and threading two M5 hex nuts together and tightening against each other with two wrenches as a “jam nut” setup. Test fit and install all parts carefully before applying any thread locker. All ball bearings, screws, nuts, rods, and filament purchased at Amazon.com.
| 8mm_Wrench.stl | 28.2KB | |
| Battery_Tray.stl | 686.2KB | |
| Bogey_Arm_Imp.stl | 178.0KB | |
| Canopy_Front.stl | 353.2KB | |
| Canopy_Rear.stl | 292.9KB | |
| Chassis_Front.stl | 295.8KB | |
| Chassis_Rear.stl | 2.9MB | |
| Drive_Wheel.stl | 1.1MB | |
| Front_Wheel_Mount.stl | 432.5KB | |
| Gear1.stl | 683.4KB | |
| Gear2.stl | 352.1KB | |
| Gear3.stl | 768.5KB | |
| Idler_Wheel.stl | 903.4KB | |
| RC_Tank_Inst.docx | 10.5KB | |
| Track_longer_wider_TPU.stl | 19.0MB | |
| Track_tpu.stl | 9.0MB |
