This little guy was made to replace a broken rear bumper on an RC10GT, so far it works great. It IS a VERY tight fit, and should be since the original was also very tightly fit. I beefed it up as much as I dared to, and printed in ABS so hopefully that'll do the job for good but you could probably print it in PLA if you dont care about replacing them regularly with new prints.
So far it's nice and stiff and strong. Please don't go selling this, it's freely given to use for all.. I didnt make it to make you money, I made it for everyone to enjoy vintage RC. As more parts break or i find things I need I'll probably make more parts for the RC10GT too.
| RC10GT_Rear_Bumper.stl | 332.6KB |
