RC Tower Crane 1.42m 56in 3D Printer Model
The file 'RC Tower Crane 1.42m 56in 3D Printer Model' is (stl) file type, size is 2.3 MB.
The file 'RC Tower Crane 1.42m 56in 3D Printer Model' is (stl) file type, size is 2.3 MB.
Recommended items to complete this crane are hot glue, BBQ skewers, Popsicle sticks, rubber bands, 30 minute epoxy, kite string, small-sized hand-held drill and bits, four 360 degree rotating 9 gram servos, one receiver, transmitter, and batteries.
The Boom is 4ft 8in, 1.4m long.
The crane was a bit of a challenge. I made it from scratch going off of only what I knew about cranes and how they worked. it took me about a week to actually print everything off. I went through many different design changes to make everything work.
NOTE!!!
Many of the parts are grouped together for convenience in printing, individual Parts if you don't want to put it in groups are at the bottom of the list you don't need to print every single thing on here most of them are covered in the upper section parts list.
| 1st_AFT_Tram_Servo_setion.stl |
| 1st_FWD_Tram_Servo_setion.stl |
| Base_x_1.stl |
| Boom_Servo_bracket_x_1.stl |
| Center_TarmBoom_setion_x_1.stl |
| Center_top_hook_hoist_x_1.stl |
| Center_tower_top.stl |
| Counterweight_bucket_x_1.stl |
| hoist_servo_mount.stl |
| hook.stl |
| NEW_Base_x_1.stl |
| NEW_Tower_section_x_8.stl |
| NEW_Turntable_bottom__x_1.stl |
| Optional_1.5_lb_Bucket_x1.stl |
| Optional_2_part_spool.stl |
| Optional_5_wheel_pully_setup_add_on.stl |
| Optional_Counterweight_TALL_bucket_x_1.stl |
| Optional_Larger__wheel_rig.stl |
| Optional_Stab_Arm.stl |
| Optional_Stab_Center_x_1.stl |
| Optional_Stab_Foot_Flat_x5.stl |
| Optional_Stab_Foot_half_sphere_x_5.stl |
| Pin_for_tower_top.stl |
| replacment_hoist_wheelif_needed.stl |
| slide_roller_frame.stl |
| slide_roller_tram_Wheel.stl |
| slide_roller_wheel.stl |
| Slide_roller_x_2.stl |
| small_hoist_adapter.stl |
| T-arm_ending_x_2.stl |
| T-arm_x_9.stl |
| Tower_section_x_8.stl |
| Tram_arm_servos_and_reals_x_1.stl |
| Turntable_bottom_x_1.stl |
| Turntable_x_1.stl |
