Update 2024-03-28
Added a new propeller, "Gotland prop v2 in the parts list". The real shape of these props are quite hard to find as they are kept as military secrets, but this prop is a mix between ease of printing, rigidity and ish-scale.
Update 2020-08-25:
Update 2019-06-10:
Update 2019-01-08:
This is the Swedish submarine HMS Gotland in scale 1/48 ment for radio controll.
The project is ongoing and will update along the way. I'm also grateful for any suggestions on improvements, either on printeability, scale look or function.
Some details on the concept:
No expensive parts shall be required, except regular rc equipment (not 2,4ghz, as it doesn't work underwater)
No or minimal need for support, all sections shall print okay without support if oriented correctly, except section 7 that needs support for the access hatch.
Static diver, my plan in to use a so called high pressure pump ballast system where a washer fluid pump will serve as pump.
A standard 3" / 75mm PVC pipe (sold as sewer pipes) will be used as dry hull/WTC, and ballast tank.
She is a little over 60m long, so a scale of 1/48 gives 1.25m.
Fun fact is that Gotland with it's stirling engines sneaked by the sonar defences and "sank" USS Ronald Reagan during an exercise in 2005 (well, at least photographed her within effective torpedo range).
Aux1.stl |
Aux2.stl |
Aux3.stl |
Fin_Port_Lower.stl |
Fin_Port_Upper.stl |
Fin_Sail_Port.stl |
Fin_Sail_Stb.stl |
Fin_Stb_Lower.stl |
Fin_Stb_Upper.stl |
Gotland_prop_v2.stl |
Sail_v3.stl |
Sail_v3_part2.stl |
Section_1_Bow.stl |
Section_1_Bow_without_torpedo_hatches.stl |
Section_2.stl |
Section_3.stl |
Section_4.stl |
Section_5.stl |
Section_6.stl |
Section_7_Access_hatch.stl |
Section_7_Stern.stl |
Section_8_stern.stl |
Torpedo_hatch_center_port.stl |
Torpedo_hatch_center_stb.stl |
Torpedo_hatch_lower_port.stl |
Torpedo_hatch_lower_stb.stl |
Torpedo_hatch_outer_port.stl |
Torpedo_hatch_outer_stb.stl |
WTC_cap.stl |
WTC_cap_flat.stl |