Update Feb 2020, I added the 1 part sprocket because i was sick of seeing people use the unreliabe 2 part one. I also added the v4 track with the reinforced center seam and the v2 a-arms with the two holes option. Also the wheels were missing apparently. They have being added now.
Hopefully people will appreciate the small touch!
//
These are still the free version 1 files, you can get all the latest files here : www.rccreations.shop/shop
I figures i would upload things to thingiverse instead of my dropbox.
Feel free to share what you make! :)
//
All printed at 0.2 or 0.3 layer height, 6 perimeters, 4 bottom, 5 top layers, 20% infill, 220 Celsius.
//
Here is what you need to know to do the conversion :
Stuff needed in this kit. Yes electronics is one, but you also need some comon hardware like a 3mm rod (allu or brass), a 6mm rod (30mm long), four 1/8 colars, a bunch of screws(M2,M3,M4...) & washers and a bit of glue and finally, a 16 gauge (1.6mm) wire (rust proof), fense wire works great.
The tunnel in made of a thin sheet of steel or aluminium bent and cut. Dimensions in the video
Transmission.
It uses two 6x13x5 bearings, and two (12x18x4) (latest files only). A 56t spur gear and a 14-20t pinion gear from traxxas is used for gears. (look for 56t 32p gear and you should find it...)
Also a few m2 and m3 screws will be needed.
Electronics,
I have in my snowmobile a castle creation Sct brushless combo, a exi steering servo(metal gear) and a spectrum transmitter dx2e and receiver combo. All that coupled to a 3s 2200 mAh from Gens Ace
Shocks, for this kit you are going to need two 60-78mm shocks for the front, one 55-60mm for the middle, and one 70-80 mm for the rear.
//
Here are some of the TOOLS you are going to need to proceed to this operation
-box cutter
-lighter
-screwdriver
-magnet (optionnal)
-pliers
-sheet metal scissors
-a candle
-ruler
-pencil
-drill and drill bits
-vice (optionnal but really helps)
-soldering iron (optionnal)
| A-arms_DEF.stl | 1.4MB | |
| base.stl | 201.4KB | |
| bottom_gear.stl | 149.1KB | |
| drive_drum_1_piece.stl | 1.2MB | |
| left_skid.stl | 651.5KB | |
| right_skid__mid.stl | 680.8KB | |
| running_boards.stl | 92.5KB | |
| Servo_holder_DEF3.stl | 160.6KB | |
| Skid_accesories_DEF3.stl | 397.7KB | |
| top.stl | 262.4KB | |
| top_gear.stl | 256.5KB | |
| TRACK_v3.1_x2_DEF.stl | 147.9KB | |
| Wheels_DEF3.stl | 373.7KB |
